Belden Hirschmann GRS1040 Referenzhandbuch Seite 1094

Tab. 73:
Id Attribute
0x8 Interface state
0x9 Admin State
0xA Interface label
Tab. 74:
Id Attribute
0x6 Ethernet Interface
4 Index
0x6 Port Control
5
0x6 Interface Utilization
6
0x6 Interface Utilization
7 Alarm Upper
Threshold
0x6 Interface Utilization
8 Alarm Lower
Threshold
0x6 Broadcast limit
9
0x6 Ethernet Interface
A Description
UM Config GRS1040
Release 8.7 04/2021
Instanz-Attribute (Forts.)
Access
Rule
Get
Set/Get USINT
Get
Hirschmann-Erweiterungen des Ethernet-Link-Objekts
Access
Rule
Get
Get/Set DWORD
Get
Get/Set USINT
Get/Set USINT
Get/Set USINT
Get/Set STRING
Data type Description
USINT Current state of the interface:
0: Unknown interface state
1: The interface is enabled
2: The interface is disabled
3: The interface is testing
Administrative state:
1: Enable the interface
2: Disable the interface
SHORT-STRING Human readable ID
Data type Description
USINT Interface/Port Index (ifIndex out of
MIBII)
0: Link state
1: Link admin state
8: Access violation alarm (read-only)
9: Utilization alarm (read-only)
USINT The existing Counter out of the private
MIB hm2IDiagfaceUtilization is used.
Utilization in percentage (Unit
1%=100, %/100). RX Interface
Utilization.
Within this parameter the variable
hm2DiagIfaceUtilizationAlarmUpperT
hreshold can be accessed. Utilization
in percentage (Unit 1%=100).
RX Interface Utilization Upper Limit.
Within this parameter the variable
hm2DiagIfaceUtilizationAlarmLowerT
hreshold can be accessed. Utilization
in percentage (Unit 1%=100). RX
Interface Utilization Lower Limit.
Broadcast limiter Service
(Egress BC-Frames limitation,
0=disabled), Frames/second
Interface/Port Description
(from MIB II ifDescr), for example
"Unit: 1 Slot: 2 Port: 1 - 10/100 Mbit
TX" or
"unavailable", max. 64 Bytes.
Industrieprotokolle
16.3 EtherNet/IP
(0=link down, 1=link up)
(0=disabled, 1=enabled)
433