Belden Hirschmann GRS1040 Referenzhandbuch Seite 1093

Industrieprotokolle
16.3 EtherNet/IP
Tab. 73:
Id Attribute
0x2 Interface Flags
0x3 Physical Address
0x4 Interface Counters
0x5 Media Counters
0x6 Interface Control
0x7 Interface type
432
Instanz-Attribute (Forts.)
Access
Rule
Get
Get
Get
Get
Get/Set STRUCT of:
Get
Data type Description
DWORD Interface Status Flags:
0: Link State (0=No link, 1=Link)
1: Duplex mode (0=Half, 1=Full)
2: Auto-Negotiation Status
3:
4:
5: Manual configuration require reset
6: Hardware error
ARRAY of: MAC address of physical interface
6 USINT
STRUCT of: InOctets, InUcastPackets,
InNUcastPackets, InDiscards,
UDINT
InErrors, InUnknownProtos,
MibIICounter1
OutOctets, OutUcastPackets,
UDINT
OutNUcastPackets, OutDiscards,
MibIICounter2
OutErrors
...
STRUCT of: Alignment Errors, FCS Errors, Single
Collision, Multiple Collision, SQE Test
UDINT
Errors, Deferred Transmissions, Late
EthernetMib
Collisions, Excessive Collisions, MAC
Counter1
TX Errors, Carrier Sense Errors,
UDINT
Frame Too Long, MAC RX Errors
EthernetMib
Counter2
...
WORD ControlBits 0: Auto-negotiation enable/disable
1: Duplex mode (0=Half, 1=Full),
UINT Interface speed in MBits/s: 10,100,...,
ForcedInterface if Auto-negotiation disabled
Speed
USINT Type of interface:
0: Unknown interface type
1: The interface is internal
2: Twisted-pair
3: Optical fiber
0x0=Auto-Negotiation in progress
0x1=Auto-Negotiation failed
0x2=Failed but speed detected
0x3=Auto-Negotiation success
0x4=No Auto-Negotiation
(always 0 because it is not
needed)
Control Bits:
(0=disable, 1=enable)
if Auto-negotiation disabled
UM Config GRS1040
Release 8.7 04/2021