Makita FN001G Betriebsanleitung Seite 9

ASSEMBLY
CAUTION:
Always make sure that your
fingers are not placed on the switch trigger or
the contact element and the battery cartridge is
removed before carrying out any work on the
nailer.
Loading or unloading the nails
CAUTION:
Always make sure that your fin-
gers are not placed on the trigger and the battery
cartridge is removed before loading nails.
CAUTION:
Do not abruptly slide the slide
door of the nailer loaded with nails. Accidentally
dropping nails especially when working in high places
may cause personal injuries.
CAUTION:
Load nails in the correct direction.
Loading in wrong direction may cause premature
wear and tear of the driver and damage of the other
parts.
CAUTION:
Do not use deformed nail strips.
Use nails specified in this manual. Using nails other
than those specified may cause nail jamming and
breakage of the nailer.
1. Press the lock lever and open the slide door of the
magazine.
► Fig.8: 1. Lock lever 2. Slide door 3. Magazine
2. Set a nail strip so that the nail tips touch the bot-
tom of the magazine and slide the nail strip toward the
driver guide.
► Fig.9: 1. Nails 2. Slide door 3. Driver guide
3. Return the slide door to the original position until
the lock lever locks it.
To remove the nails, press the lock lever and slide the
slide door. Take out nails from the magazine.
Nose adapter
CAUTION:
Always make sure that your
fingers are not placed on the switch trigger or
the contact element and the battery cartridge is
removed before installing the nose adapter.
When firing nails on the material with easily-marred
surfaces, use the nose adapter. Put the adapter onto
the pointed end of the driver guide.
You can store the nose adapter in the holder at the back
end of the magazine to keep it from being lost.
► Fig.10: 1. Nose adapter 2. Driver guide 3. Holder
Hook
CAUTION:
When installing the hook, always
secure it with the screw firmly. If not, the hook
may come off from the tool and result in the personal
injury.
CAUTION:
Use the hanging/mounting parts
for their intended purposes only. Using for unin-
tended purpose may cause accident or personal
injury.
CAUTION:
Do not hang the hook from the
waist belt. Dropping the nailer, which is caused by
the hook accidentally coming out of place, may cause
unintentional firing and result in personal injuries.
► Fig.11
The hook is convenient for temporarily hanging the tool.
This can be installed on either side of the tool.
To install the hook, insert it into a groove in the tool
housing on either side and then secure it with a screw.
To remove, loosen the screw and then take it out.
► Fig.12: 1. Groove 2. Hook 3. Screw
Hex wrench storage
When not in use, store the hex wrench as shown in the
figure to keep it from being lost.
► Fig.13: 1. Hex wrench
OPERATION
Testing the safety system
WARNING:
Make sure all safety systems are
in working order before operation. Failure to do
so may cause personal injuries.
► Fig.14: 1. Trigger-lock button 2. Switch trigger
3. Contact element 4. Magazine
Test safety systems as follows for possible fault before
operation.
1. Unload nails from the tool and keep the magazine
opened.
2.
Install the battery cartridge and release the trigger
lock.
3. Pull the switch trigger without touching the contact
element against the material.
4. Touch the contact element against the material
without pulling the switch trigger.
If the tool operates in the case of 3 or 4 above, the
safety systems are faulty. Stop using the tool immedi-
ately and ask your local service center.
9 ENGLISH