EcoDim Eco-Dim.05 Zigbee Benutzerhandbuch Seite 22

3 REMOVE: There are two methods to remove the device from the Zigbee network.
From your Zigbee Hub interface, choose to wipe or reset the device according to
METHOD 1.
the instructions.
METHOD2.
Step 2. The indicator
will start blinking purple
and stay on for 10
seconds when the
removal is complete.
Timeout 3 minutes.
4 TOUCHLINK: Right channel only), For left channel please see Find and Bind section
Please note: TouchLink takes effect when both devices have not been added to a ZigBee network and each
device can be connected to a remote control
Step 2. The indicator
starts blinking green
and stays solid for 10s
when pairing is
succeeds. Time out
15mins.
Step 3. .Bring the remote within 10cm of the smart dimmer and set the remote into
TouchLink commissioning.
Step 1. Press the reset
button three times.
Step 1. Press the reset
button for 4 times.
20