COMFORTPOOL CP-80023 Installation / Benutzerhandbuch Seite 20

9. When glue is dry, screw to 4-way valve. Note: the elbow should face downwards
10. Connect the hose of the filtration system (hose disconnected from step 6) to Port A of the 4-way valve
and connect the inlet pipe of the solar heater to port B of the 4way valve, then connect the outlet pipe of
the solar heater to port C of the 4way valve, all use stainless steel clamps to tighten.
11. Remove the plug from the backflow of the pool, turn on the valve for the filtration system, and make
sure water flow is freely in all the piping.
12. Plug in the power supply, start the pump, the water begins to circulate, and enter the pool and solar
heater, respectively. The water entering the solar heater passes through the outlet pipe of the four-way
valve and returns to the pool.
Port A – connect to
filtration system
Remove the plug
Port B – connect to inlet
pipe of the solar heater
Port C – connect to
outlet pipi of the solar
heater
Open the valve of the
filtration system
20