MA lighting grandMA3 onPC Fader Wing Bedienungsanleitung Seite 16

Connect and Power Up the Device
1. Unpack the device.
2. Remove the packaging and cushioning material.
3. Place the device indoors on a stable surface.
4. Download the grandMA3 onPC software on www.malighting.com
5. Install the software on your PC or laptop. For minimum requirements see System Requirements grandMA3 in the grandMA3
user manual.
6. Connect the grandMA3 onPC fader wing with your command wing XT, PC or laptop using a USB cable.
7. Start the command wing XT, PC or laptop .
8. Switch on the grandMA3 onPC fader wing:
-Insert the IEC connector into the corresponding jack.
-Connect the main power plug.
-Turn on the power switch:
-Set it to position I.
-The power switch lights up in red.
Turn off the grandMA3 onPC fader wing
To turn off the grandMA3 onPC fader wing set the power switch to position 0.
Important:
-Show data is only saved in the grandMA3 onPC software.
-For updates use the grandMA3 onPC software.
Important:
You can disconnect the grandMA3 onPC fader wing using the grandMA3 onPC software. The DMX output will then be
interrupted immediately.
16
Intended Use
Safety
Support
Transport
Limitations
Quick Start
Maintenance
Disposal
Technical Data
Declaration of Conformity