DJI AGRAS T30 Kurzanleitung Seite 6

Using the T30
1. Preparing the Intelligent Flight Battery
Only use official DJI flight batteries (model: BAX501-29000mAh-
51.8V). Check the battery level before flying and charge according to
the corresponding manual document.
2. Preparing the Aircraft
M2
Unfold the M2 and M6 arms, and fasten the
two arm locks. Avoid pinching fingers.
Unfold the propeller blades.
Make sure that the battery is firmly inserted into the aircraft. Only insert or remove the battery when the aircraft
●
is powered off.
To remove the battery, press and hold the clamp and lift the battery up.
●
Fold the M3 and M5 arms followed by the M2 and M6 arms and make sure that the arms are inserted into the
●
storage clamps on both sides of the aircraft. Otherwise, the arms may be damaged. Lift and lower the M1 and
M4 arms gently to reduce wear and tear.
M2
M6
M3
Unfold the M3 and M5 arms followed by M1 and M4 and
fasten the four arm locks. Avoid pinching fingers.
Insert the Intelligent Flight Battery into the aircraft
until you hear a click.
M1
M6
M5
M4
5