Inline 32316P Bedienungsanleitung Seite 20

www.inline-info.com
data detection are complete, but the PD still does not work, the corresponding port of the
switch is turned off for a few seconds and the power supply to the PD is then restarted.
The switch-off time can be set between 5-60 seconds using the up/down keys.
20
01: SWITCH MODE
The switch has 3 modes to choose from:
Normal: Standard mode of the switch
VLAN: The switch supports the isolation of each port, but
each port can still communicate with the uplink port
CCTV: The switch supports a maximum distance of 250
meters with a transmission speed of 10 Mbps
02: SWITCH BANDWIDTH
There are four options to choose from:
Cancel: You do not need to re-select the bandwidth after
you have previously set it.
400Mbps, 500Mbps, 600Mbps: You can freely choose
between these bandwidths, for example, depending on
the connected device or the available Internet connection.
03: PD TYPE
The switch supports 3 types of PD (powered devices):
PoH UPOE: Select this mode when using a PD without
support according to IIEEE802.3bt/at/af.
802.3 BT: Select this mode when using a PD according
to IEEE802.3bt/at/af.
Legacy: Select this mode if you are using a Cisco PD with
its own PoE standard.
04: PD REBOOT
PD Reboot means that the switch supports the restart of
the PD (powered device). The corresponding port can be
selected and activated/deactivated using the up/down
keys. When connected to a PD, the start time can vary
between 60-300 seconds and can be set using the up/
down keys.
The following automatic data recognition can also be
selected between 60-300 seconds. After power-on and
info@inline-info.com