HP DesignJet 1000 Serie Installationshandbuch Seite 9

15 Turn on the printer using the power button on the front panel, and use the front
panel as follows to verify that the PostScript module has been installed in your
printer.
Press ENTER.
R eady
In k
CYAN
M A G E N TA
Y E L L O W
B L A C K
Press ↓ until Utilities is highlighted.
Printer setup options
Image quality ...
Device setup ...
I/O setup
Utilities ...
Demos ...
Press ENTER.
Utilities
Display Contrast...
Statistics...
Recover Printheads...
Calibrations ...
Test Prints...
or ↑ until Statistics is highlighted and then press ENTER.
Press ↓
Statistics
RAM present=
Hard Disk=
Code rev=
PS Code rev=
If the PostScript module has been successfully installed, you should see the line "PS
followed by a version number.
Code rev="
Install the HP DesignJet PostScript Upgrade
OK
7