HP DesignJet 1000 Serie Installationshandbuch Seite 5

4 Unscrew the four screws and remove the cover plate at the back of the printer.
NOTE: To prevent loss of these screws, loosely re-install them in the printer.
5 Looking at the back of the printer, you will see three slots. It is important to install
the PostScript module in the slot that is furthest to the right.
6 Put on a grounding wrist strap and attach the other end to the metal chassis of the
printer.
Install the HP DesignJet PostScript Upgrade
Cover Plate
3