Is There A Problem - K&H 5Z-MKG Gebrauchsanleitung

Use cookware the diameter of which is at least as large as the cooking area so that all of the heat
produced by the heating element is used.

Make sure that the bottom of tile pot is always dry and clean to insure good contact
between the cookware and the cooking surface. This will also increase the life of the pots
and of the ceramic glass surface as well.

Do not use the same cookware that you use for gas burners because the concentrated
heat they produce can deform the bottom of the pot. Therefore, you will not achieve best
results when using these pots on the ceramic glass surface.
Notice: The glue used to seal the glass surface may leave traces on the appliance. We
recommend that the module be cleaned with a non-abrasive cleaner before being used the first
time. During the first few hours of use, you may detect the smell of rubber; this will disappear after
a short time.
5 IS THERE A PROBLEM WITH GAS HOB?
It may occur that the cooktop does not function or does not function properly. Before calling
customer service for assistance, let's see what can be done. First of all, check to see that there
are no interruptions in the gas and electrical supplies, and, in particular, that the gas valves for
the mains are open.
The burner does not light or the flame is not uniform around the burner.
Check to make sure that:
● The gas holes on the burner are not clogged;
● All of the movable parts that make up the burner are mounted correctly;
● There are no draughts around the cooking surface.
The flame does not stay lighted on the model with the safety device.
Check to make sure that:
● You press the knob all the way in;
● You keep the knob pressed in long enough to activate the safety device.
● The gas holes are not clogged in the area corresponding to the safety device.
The burner does not remain on when set to "Low".
Check to make sure that:
● The gas holes are not clogged.
● There are no draughts near tire cooking surface.
● Tile minimum has been adjusted correctly (see the section entitled, "Minimum Regulation").
The cookware is not stable.
Check to make sure that:
● The bottom of the cookware is perfectly flat.
● The cookware is centered correctly on the burner or electric hot plate.
● The support grids have not been inverted.
If, despite all of these checks, the cooktop does not function properly and problem persists, call
your supplier's Customer Service Centre informing them of:

Tile type of problem.

The abbreviation used to identify the model (Mod.... )as indicated on tile warranty.

Never call upon technicians not authorized by the manufacturer, and refuse to accept
spare parts that are not original.
29