Technical Data - Formula 1 PM400 Originalbetriebsanleitung

Technic al
data
Model PM400
Item number 10788
Input
Input alternating cur-
rent frequency
Power input 1200 W
Speed 600 -
3000 min
Backing plate 180 mm
Sound pressure level 83,0 dB(A) /
L / K 3,0 dB(A)
PA PA
Sound power level 94,0 dB(A) /
L / K 3,0 dB(A)
WA WA
Hand-arm vibration 2.814 m/
a / K s² (main
h,P
handle),
4.211 m/s
(auxil-
iary handle),
5.7 m/s
(power tool)
/ 1.5 m/s²
Weight 2,6 kg
Ambient temperature
Storage temperature
Protection class Class II
Note:
The sound and vibration values were measured in
accordance with EN 62841-1 and EN 62841-2-4.
The vibration values specified and the noise
emission levels determined were measured
according to a standardised test procedure and
can be used to compare different power tools.
The total vibration values specified and the noise
emissions specified can also serve as a prelimi-
nary assessment of the strain.
Prolonged use may cause in fatigue due to vibra-
tion and noise. Allow adequate breaks.
The actual vibration value whilst using the ma-
chine may vary from that stated in the operating
instructions or by the manufacturer. This can be
PM600
caused by the following factors which should be
10790
taken into account before and during every use:
•
230-240 V AC
•
•
50 Hz
•
900 W
If you notice an uncomfortable feeling in your
0 -
hands or discolouration of the skin whilst using
6000 min
-1 -1
the machine, stop immediately. Take adequate
work breaks. Failure to take adequate breaks can
150 mm
cause hand-arm vibration syndrome.
80,27 dB(A)
The degree of stress resulting from the work and
/ 3,0 dB(A)
use of the machine should be assessed and work
91,27 dB(A) breaks taken accordingly. This can significantly
/ 3,0 dB(A)
reduce the degree of stress during the entire
work duration. Minimise the risk to which you are
6.759 m/
exposed through vibrations. Care for this machine
s² (main
in accordance with the operating instructions.
handle),
13.078 m/s
2 2
If the machine is used on a regular basis, you
(auxil-
should contact your specialist dealer and pur-
iary handle),
chase anti-vibration accessories (handles).
5.7 m/s
2 2
(power tool)
Avoid using the machine at temperatures of
/ 1.5 m/s²
t=10° C or below. Prepare a work schedule that
allows vibration stress to be limited.
2,6 kg
A certain amount of noise exposure from this
-20 °C ~ +40 ºC
device is unavoidable. Schedule noisy work for
the intended and permitted times. Observe any
-15 °C ~ +40 °C
customary quiet periods and keep the duration
of your work to the absolute minimum. Hearing
protection should be used to protect yourself and
persons nearby.
Warning!
Is the device being used correctly
Is the type of material being worked on correct.
Is the device in good condition
Are the handles or optional vibration handles
installed and tight on the machine body.
Polishing Machine PM400, PM600
EN
19