S&P TD EVO Bedienungsanleitung Seite 26

• This appliance can be used
by children aged from 8 years
EN
and above and persons with
reduced physical, sensory or
mental capabilities or lack of
experience and knowledge if
they have been given supervi-
sion or instruction concerning
use of the appliance in a safe
way and understand the ha-
zards involved. Children shall
not play with the appliance.
Cleaning and user mainte-
nance shall not be made by
children without supervision.
SAFETY DURING INSTALLATION
Fan unit equipment should be electrically isolated
and locked out before any work started.
The Installer, User is responsible for ensuring that the
fan unit is installed, operated and serviced by quali-
fi ed personnel, acting in accordance with all safety
precautions applicable and as required by law, regula-
tions and standards in the country applicable.
Safety protective clothing, equipment, hearing protec-
tion, and tools may be required.
Before any installation work is started, ensure that fan
unit equipment is correct for application. Location for
installation is solid, level, fl at and suitable for moun-
ting fan unit assembly.
Fan unit should be located in position, and assembled
with any accessory equipment supplied, on relevant
mounting, anti-vibration mountings, safety protection
guards, on a solid level base to avoid any distortion
and misalignment and with correct air direction as
shown on nameplate. Fan unit should then be levelled
on any anti-vibration mountings. Flexible connectors
must be taught to ensure no disruption to air fl ow, es-
pecially on inlet to fan unit.
Make sure there are no loose elements near the fan
unit. When the fan unit is mounted in a duct, check
that it is clean of any elements and exclusively used
for ventilation system.
The electrical installation must include a double pole
switch with a contact clearance of at least 3 mm, co-
26
rrectly sized and in accordance with the electrical
standards of the country of installation.
For electrical connections follow the wiring diagram
"A" indicated in this manual.
The fan unit classifi ed as Residential Ventilation Unit
with control factor 0,65 have to comply with the re-
quirements of the European Directive 2009/125 and
must be installed following the local demand control
defi nition given in the regulation nº1253/2014 (See
fi g.B as example).
START UP
• Check fan unit equipment name plate data is appro-
priate to the location electrical supply, especially
Voltage, Frequency, Phase, Amps, speed are co-
rrect.
• Check earth connections, electrical terminations
and terminal box lid, with any seals, if fi tted, are co-
rrect.
• In compliance with Machine Directive, if the fan unit
is accessible to operators and is a health and safety
risk, adequate protection must be fi tted, informa-
tion for safety equipment, including guards, can be
found in S&P accessories catalogue.
• Check all rotating parts have free, unobstructed
movement.
• Check there are no foreign bodies inside the fan unit
or that can be drawn into, or fall into fan unit.
• Check the structure is complete and has no dama-
ge. Check installation and area is safe and energise
fan unit and start motor.
• Check that the impeller and airfl ow direction is co-
rrect, and there are no unusual vibrations.
• Check current does not exceed fan equipment na-
meplate data.
• If any of the electrical safety devices blow, the fan
unit must be quickly disconnected from the mains
supply. The whole installation should be carefully
checked before trying to start up the fan again. Af-
ter two hours of operation, check that all fi xings are
tight and adjust if necessary.
PUTTING OUT OF SERVICE AND RECYCLING
Maintenance/repairs must be carried out by com-
petent and local regulations. Fan unit equipment
should be electrically isolated and locked out before
any work started.
Fan unit equipment should be regularly cleaned, fre-
quency depending upon service load and application,
but no less than every year. Cleaning should include all
areas where dust can accumulate in the fan equipment.