Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
GHE 260.0/GHE 260.0 S:
In accordance with
Directive
2000/14/EC:
Guaranteed sound
power level L
102/101 dB(A)
WAd
In accordance with
Directive
2006/42/EC:
Sound pressure level
at workplace L
89/91 dB(A)
pA
Uncertainty K
3 dB(A)
pA
Bolt tightening torques:
Blade disc
50 Nm
Reversible blade
10 Nm
2
Shredding blades
10 Nm
Weight
27/27 kg
L/W/H
107/48/143 cm
1)
Caution!
In the case of mains fuses of less
than 16 A, these may be tripped dur-
ing start-up or in the case of high
load operation of the machine.
2)
for modelsGHE 250.0 and
GHE 260.0
17.1 REACH
REACH is an EC Directive for the
registration, evaluation, authorisation and
restriction of chemicals.
Information on compliance with the
REACH Directive (EC) No. 1907/2006 is
available from www.stihl.com/reach.
50
18. Troubleshooting
If necessary, contact a specialist
dealer; STIHL recommends STIHL
specialist dealers.
Fault:
Motor does not start
Possible cause:
– Motor overload protection activated
– No mains voltage
– Electric cable, plug, plug connector or
switch defective
– Feed chute not properly closed - safety
cut-off switch actuated (motorstop)
– Blade disc blocked
– Locking device is not reset
Remedy:
– Allow machine to cool down (
– Check power cable and fuse
(
10.1)
– Check cable, plug, connector and
switch and replace if necessary (by
electrician)
(
10.1)
– Close feed chute properly and tighten
screws (
11.2)
– Remove feed chute and remove
shredder deposits from the housing
(Important: disconnect the power cable)
(
11.3)
– Reset locking device (
Fault:
Reduced shredding performance
Possible cause:
– Blunt blades
Remedy:
– Reverse, re-sharpen or replace
shredding blades
(
Fault:
Shredding material is not drawn in
Possible cause:
– GHE 260: Incorrect rotational direction
of blade disc
Remedy:
– GHE 260: Change rotational direction
of blade disc (
19. Service schedule
19.1 Handover confirmation
8.6)
11.4)
19.2 Service confirmation
Please hand this instruction manual
to your STIHL specialist dealer in
the case of maintenance operations.
He will confirm the service operations
performed in the pre-printed boxes.
11.7)
10.6)
23
0478 201 9913 C - EN
Werbung
Kapitel
Inhaltsverzeichnis
