English; Care And Cleaning - Kenwood A941 Kurzanleitung

All manuals and user guides at all-guides.com
Use the grainmill to mill a range of
cereals including wheat, rye,
buckwheat, husked barley, millet and
rice. Oats can also be ground but a
coarse setting should be selected.
All the cereals must be dry otherwise
the mill will clog.
safety
G
Do not place your fingers or any
other item down the feed tube.
G
Keep fingers away from moving
parts.
G
Never attach or remove the grainmill
whilst the mixer is in operation.
G
Never assemble or dismantle the
attachment on the mixer.
before using for the first time
G
Wash the parts see 'care and
cleaning'
key
hopper
grainmill body
scroll
milling ring
milling cone
adjusting control
ring nut
to assemble
1 Insert the scroll into the grainmill
body.
2 Add the milling ring ensuring that it
locates in its recess.
3 Fix the milling cone in position.
4 Add the adjusting control, ensuring
that the slot fits into the locating peg
at the bottom of the grainmill body.
5 Place the ring nut in position and
tighten by turning clockwise.
6 Fit the hopper.

English

to use the grainmill
The assembly and location of the
grainmill onto the mixer is easier if
the fine setting has been selected on
the grainmill.
1 Pull the catch
slow speed outlet cover
2 Hold the catch back and insert the
grainmill. Turn it both ways until it
locks into position. Release the
catch to lock.
3 Fill the hopper with grains, a
maximum 750g – 1 Kg can be
accommodated depending upon the
cereal.
4 Select the desired grain size by
turning the adjusting control to the
left (anticlockwise) for a finer result
and to the right
coarser result.
important
Never turn the adjusting control
passed the "stop" line.
5 Once the desired setting is selected,
switch the mixer to maximum speed
ensuring that there is a collecting
vessel below the outlet.

care and cleaning

Before removing your grainmill from
the mixer, switch off and disconnect
from the power supply. Remove the
grainmill from the slow speed outlet
and dismantle. The metal
components can be cleaned with a
dry coarse brush and the remainder
washed in hot soapy water and
dried thoroughly.
2
and remove the
.
(clockwise) for a