Behringer EUROLIVE B115W Kurzanleitung Seite 22

22
B115W/B112W
EUROLIVE B115W/B112W Getting started
Step 3: Getting
(EN)
started
Place the speaker(s) in desired locations,
either on stands or as wedge monitors
on the floor.
Make all necessary connections.
DO NOT turn on the power yet.
Turn on your audio source
(mixer, microphone).
Turn on your speaker(s) by pressing the
POWER SWITCH. The POWER LED will
light up.
Play your audio source or speak into your
microphone at a normal to loud level.
Adjust the LEVEL knob to the desired
volume. If the CLIP LED flashes,
turn the LEVEL knob down. If using
multiple speakers, the LEVEL knob must
be adjusted on each speaker.
If necessary, adjust the HIGH and
LOW EQUALIZER knobs on each speaker
to boost or cut treble and bass
frequencies to taste.
Optional wireless microphone set-up
Only insert the optional Behringer
DIGITAL WIRELESS microphone
receiver into the input.
Activate the microphones by pressing the
VOLUME UP button on each microphone.
During the pairing process, the LED
on the dongle will flash. Once the
connection between the wireless
microphone and the receiver is achieved,
the LED will remain on (solid).
Speak into the wireless microphones
and adjust the volume using the volume
buttons on the individual microphones.
Press the volume down button for two
seconds to mute the microphone signal.
Press the volume up button to unmute
the microphone.
Bluetooth connection procedure
NOTE: These Bluetooth speakers can only link with
another speaker of the same model. For example, a
B112W speaker will only link with another B112W.
Make sure Bluetooth is enabled on your
Bluetooth device.
Turn the BLUETOOTH VOLUME knob all
the way down to the MIN setting.
Press and release the STEP 1 button
to pair the speaker with your Bluetooth
device. The PAIR LED will flash while
connecting to your Bluetooth device.
When Bluetooth has successfully paired
with your device, the PAIR LED
will light solid.
• In your Bluetooth device, enter the PIN
code: 0000 (Bluetooth version 2.0 and
above will not require a PIN code).
Press and release the STEP 2 button to
link your B115W/B112W speaker with
another similar speaker. The STEREO LINK
LED will flash while connecting to your
Bluetooth device. When Bluetooth has
successfully paired with your device, the
STEREO LINK LED will light solid.
Begin playback on your Bluetooth device.
Slowly turn the BLUETOOTH VOLUME
clockwise until you find a comfortable
listening level.