Introduction - Parkside PKZ 1000 A1 Originalbetriebsanleitung

2. Introduction

Manufacturer:
scheppach
Fabrikation von Holzbearbeitungsmaschinen GmbH
Günzburger Straße 69
D-89335 Ichenhausen
Dear Customer,
We hope your new tool brings you much enjoyment and success.
NOTE:
According to the applicable product liability laws, the manufacturer of the device does
not assume liability for damages to the product or damages caused by the product that
occurs due to:
• Improper handling,
• Non-compliance of the operating instructions,
• Repairs by third parties, not by authorized service technicians,
• Installation and replacement of non-original spare parts,
• Application other than specified.
m Please consider:
Read through the complete text in the operating instructions before installing and commis-
sioning the device.
The operating instructions are intended to help the user to become familiar with the machine
and take advantage of its application possibilities in accordance with the recommendations.
The operating instructions contain important information on how to operate the machine
safely, professionally and economically, how to avoid danger, costly repairs, reduce down-
times and how to increase reliability and service life of the machine.
In addition to the safety regulations in the operating instructions, you have to meet the ap-
plicable regulations that apply for the operation of the machine in your country.
Keep the operating instructions package with the machine at all times and store it in a plas-
tic cover to protect it from dirt and moisture. Read the instruction manual each time before
operating the machine and carefully follow its information.
The machine can only be operated by persons who were instructed concerning the opera-
tion of the machine and who are informed about the associated dangers. The minimum age
requirement must be complied with.
In addition to the safety instructions contained in this operating manual and the specific
regulations of your country, the technical rules generally accepted for the operation of
machines of the same type must be observed.
GB 3