Operation; Cleaning Using Cleaning Agent; Filling And Emptying The Cleaning Agent Tank; Switching On - Parkside Performance PHDP 180 A1 Originalbetriebsanleitung

Operation

Cleaning using cleaning
agent
Requirements for the cleaning
agent
• This device has been designed to be
used with a neutral cleaning agent
based on biodegradable anionic sur-
factants.
• Use of other cleaning agents or chemi-
cals can negatively impact the safety
of the device and can cause damage.
Such damage to the device is not co-
vered by the warranty.
• you can buy cleaning agents in our
online shop.
Requirements
• The cleaning agent tank is filled with
cleaning agent.
• 3-in-1 nozzle is at foam nozzle position
for cleaning agent.
• The pistol grip pipe is at high pressure
position for walls and foam.
Filling and emptying the
cleaning agent tank
1. Remove the sealing cap with suction
hose (12) from the cleaning agent tank
2. Pull the cleaning agent tank (13) up-
ward and then to the front.
The cleaning agent tank is re-
moved.
you can fill or empty the cleaning
agent container.
3. Insert the cleaning agent tank in rever-
se order.
4. Seal the cleaning agent tank with the
sealing cap.
5. Push the suction hose into the cleaning
agent tank until it reaches the bottom.

Switching on

WARNING! A leaky water system
can result in electric shock! Move the on/
off switch (30) to the "O" (OFF) position.
Unplug the plug. Try connecting the water
connection again (see Establishing a water
supply).
WARNING! The device may only
be used in an upright position! There is a
risk of an electric shock if the device falls
over. Turn the device off immediately using
the on/off switch (30). Unplug the plug.
Only now may you bring the device into
the upright position. For your own safety,
wait about five minutes until you restore the
electrical connection.
WARNING! Unsuitable extension
cables can be dangerous! Use only exten-
sion cables that are designed for outdoor
use. The connection must be dry and
routed above the ground. We recommend
using a cable reel that holds the socket at
least 60 mm above the ground.
1. Ensure that the on/off switch (30) is in
the "O" position.
2. Insert the mains plug into an earthed
socket with residual current circuitry.
3. Put the device in an upright position.
4. NOTE! Dry running will damage the
device. Do not operate the pressure
washer with the tap turned off.
Turn the tap on fully.
5. Move the on/off switch (30) into positi-
on "I" (ON).
GB IE
33