Operational Safety - Beko RCNE560E40ZLXPHUN Bedienungsanleitung

Safety instructions
• Do not cover or block the
ventilation openings. Otherwise,
power consumption increases and
your product may get damaged.
• Product must not be connected
to supply systems such as solar
power supplies. Otherwise, your
product may get damaged due to
sudden voltage changes!
• The more refrigerant a
refrigerator contains, the larger
the installation location must
be. If the installation location is
too small, flammable refrigerant
and air mixture will accumulate
in cases of refrigerant leakage
in cooling system. The required
space for each 8 gr of refrigerant
is 1 m3 minimum. The amount
of refrigerant in your product is
indicated on the Type Label.
• Product must not be installed in
places exposed to direct sunlight
and it must be kept away from
heat sources such as hobs,
radiators, etc.
If it is inevitable to install the product
close to a heat source, a suitable
insulation plate must be used in between
and the following minimum distances
must be kept to the heat source:
- Minimum 30 cm away from heat sources
such as hobs, ovens, heater units or
stoves,
- Minimum 5 cm away from electric ovens.
• Protection class of your product
is Type I. Plug the product in a
grounded socket that conforms
the voltage, current and frequency
values stated on the type label of
the product. The socket must be
equipped with a 10 A – 16 A circuit
breaker. Our company shall not be
liable for any damages that will
arise when the product is used
without grounding and electrical
connection in accordance with the
local and national regulations.
• Product must not be plugged in
during installation. Otherwise,
there is the risk of electric shock
and injury!
• Do not plug the product in sockets
that are loose, dislocated, broken,
dirty, greasy or bear the risk of
getting in contact with water.
• Route the power cable and hoses
(if any) of the product in a way
that they do not cause risk of
tripping over.
• Exposing the live parts or power
cable to humidity may cause short
circuit. Therefore, do not install
the product in places such as
garages or laundry rooms where
humidity is high or water may
splash. If the refrigerator gets wet
with water, unplug it and call the
authorised service agent.
• Never connect your refrigerator
to energy saving devices. Such
systems are harmful to your
product.
A

1.6- Operational safety

• Never use chemical solvents on
the product. There is the risk of
explosion!
• If the product malfunctions,
unplug it and do not operate until
it is repaired by the authorised
service agent. There is the risk of
electric shock!
6 /36EN
Refrigerator / User Guide