Klarstein Bernadin Bedienungsanleitung Seite 57

Removing the Slide-In Racks
Removing the slide-in racks gives you easier access to the entire oven interior for
cleaning and maintenance of the oven.
Note: Take great care when removing to avoid damaging the enamel.
Remove all accessories
such as the grate and
baking tray from the oven.
Slightly push down the
hook on the racks at the
clamping point.
Replacing the Oven Lamp
The light used in the oven is a special high temperature resistant light (AC 220 V/25 W).
If it is defective, the lamp may only be replaced by a lamp of the same type from an
authorised distributor. When replacing the lamp, proceed as follows:
1. Unplug the appliance from the power outlet or disconnect the power supply.
2. Turn the glass cover counterclockwise (see figure 1).
3. Remove the lamp and replace it with a lamp of the same type (see figure 2).
4. After replacing the lamp, refasten the glass cover by turning it clockwise.
1
Swivel the rack inwards up to an angle of 90°.
Unhook it at the top and carefully pull it out.
Proceed in reverse order to re-insert the slide-in racks
after cleaning the oven.
2
EN
57