Electrical Safety; Assembly; Mounting Grip Rod; Assembling The Curved Handle - Grizzly Tools ERM 1500-33 LF Originalbetriebsanleitung

GB
• Check that only replacement
tools authorised by the manu-
facturer are used.

Electrical Safety:

• Ensure that the mains voltage
matches the specifications on
the rating plate.
• Connect the equipment to a
socked with a residual current-
operated protective device
(RCD) with a release current of
more than 30 mA.
• Avoid bodily contact with
earthed parts (e.g. metal fenc-
es, metal posts).
• Use only authorised power
cables of type H07RN-F,
which are no more than 75 m
long and suitable for outdoor
use. The power cable wire
cross section must be at least
2.5 mm . Always completely
2
unroll cable drums before use.
Check the cable for damage.
• To fix on the power cable, use
the cable suspension intended
for the purpose.
• Keep the power cable away
from the cutting tool when
working. The cutting blades
may damage the power cable
and result in contact with live
parts. Always run the power ca-
ble behind the operator.
• Do not use the power cable to
pull the plug from the socket.
Protect the power cable from
heat, oil and sharp edges.
• Switch off the equipment and
disconnect the plug from the
socket if the power cable is
damaged. If the power cable is
damaged, it must be replaced
64
by the manufacturer, the cus-
tomer services of the same, or
a qualified person, in order to
avoid hazards.
• Do not connect a damaged
power cable to the mains. Do
not touch a damaged power
cable when it is connected to
the mains. A damaged power
cable may result in contact with
live parts.

Assembly

Disconnect the plug before any
work on the equipment. There is a
risk of injury.

Mounting grip rod

Assembling the Curved Handle

1. Insert the lower handle (3) into
the slot in the air cushion deck
(8).
2. Attach the lower bar (3) with the
screws provided.
3. Fasten the bow-type handle
(1) with the enclosed screws,
washers and clamping levers
(2) to both right and left sides
of the lower bar (3). Two posi-
tions are possible. There are
two possible positions.
4. Turn the tightening lever (2) in
the clockwise direction.
5. 5. Lock the clamping lever (1)
by pressing it in the direction of
the bow-type handle (2)
tightening lever fit the bar so
that a tensioning with medium
force can be carried out. Other-
wise, the tightening levers must
‚
. The