Bergeon 6950-050 Gebrauchsanweisung Seite 30

Delete several tests simultaneously
Settings
Settings for the control unit
Unité
Peak
Keep control / peak
"P-2" sélectionné
Bergeon SA
2400 Le Locle / Suisse
Press the + or – key to select the highest test level (here:200) upto the one you
wish to delete (here: from 001 to 200).
Press the MD key to access the menu.
Example 1:
To remove tests from 0 to 200 press the MD key to display 200 on the screen.
A new impulsion to display stt 001.
Example 2:
To delete tests 101-200 requires that the screen displays the test 200 before
accessing the menu by pressing the MD key. Then you must validate the minimum
value (here:101) with the + or – keys. The display should display stt 101.
Example 3:
To delete all the tests the screen should display 999 before accessing the menu
by pressing the R key. Then you must validate the minimum value (here:001)
with the + or – keys. The screen should display stt 101.
Press the MD key to access the menu.
In the menu press simultaneously both the MD and C keys and then release them.
Tested values are deleted.
Before selecting the menu to configure the settings, the screen should show 0.0.
Press the MD key for two seconds.
The control unit flashes at the top right of the screen.
Press the + or – key to select the desired unit.
(cN-m ↔ mN-m ↔ gf-cm ↔ ozf-in ↔ cN-m)
To validate the chosen unit press on the MEM key.
To continue in the menu without making any changes press the MD key.
There are two methods (P-1 and P-2) to choose from for carrying out a test.
P-1: Enters the test value and stores it. If measuring continues, the next value
is memorised.
P-2: Takes the measurement value and memorises it without a next value being
entered.
To validate the selected unit press the MEM key.
To exit the menu press the C key.
To navigate the menu without making any changes press the R key.
Tél. +41 32 933 60 00 www.bergeon.ch
Fax +41 32 933 60 01 info@bergeon.ch