Bergeon 6950-050 Gebrauchsanweisung Seite 27

Bergeon SA
2400 Le Locle / Suisse
Identification of the command keys and the electronics box
a Liquid crystal display
b
Power on key
c
Positive increment key
d
Negative increment key
e
Memory key
f
Setting mode key
g
Delete key
h Device connector
i RAZ
j Cover for the battery compartment
Tél. +41 32 933 60 00 www.bergeon.ch
Fax +41 32 933 60 01 info@bergeon.ch
Displays the counter, auto-data recorder, remaining battery indicator, tourque unit and value.
Device switched on or switched off (ON/OFF).
Gradually advance the counter to see the test results. Continuous support allows the meter
to rise very quickly so values are available rapidly.
Gradually reverses the meter to show the test results. Continuous support allows for the me-
ter readings to decline at great spead so values are available rapidly.
Memorises the test data and moves the meter on for the next memorisation. The displayed
data is transmitted to the external peripheralIf the self-recorder is working (0.1 to 5 sec.) the
MEM key cannot be activated.
Direct access to the display menu of Max./Min./Average measured values. Each impulsion.
In "Peak" mode, this key lets you cancels the test values and dates.
In run mode, a preset of 0 is activated.
USB connection cable.
Always reset to 0 in the event of error or malfunction.
Removable protection for replacing battery type "battery key" reference CR2450.
The unit comes with a protective film between the battery and the cover. This film must be
removed before any first use of the device.
Test for a torque screwdriver
Select peak mode "P-2"
Before each test, ensure that the screen displays 0, otherwise press the "C" key to reset
to 0.
Retain the mandrel support for holding the kit components. Screw on the appropriate
screwdriver guide for the screwdriver.
Introduce the screwdriver and make sure it is held vertically and in particular that it is well
engaged in the insert slot.
Set the meter between 001 and 999 for the test in mode P-2.
IMPORTANT
Stability on a flat clean workbench is essential for optimum control.
!
Make sure you hold it firmly in your hand
the mandrel support while setting up
all parts of the test kit or
of the 3-jaw mandrel.