Ufesa PV1410 Gebrauchsanleitung Seite 7

SPRAY (fig. 6).
You can get an additional burst of Spray,
whether ironing dry or with steam, in the
following way:
- Press the Spray button (6) . Do not use the
spray for ironing silk as this may leave water
marks.
IRONING WITH SUPERSTEAM (fig. 7)
Just as with the Spray function you can also
get an additional burst of steam when ironing
with or without steam by doing the
following:
- Set the temperature control (8) between
the •• and Max settings and wait until the
iron reaches temperature.
- Raise the iron slightly up off the material and
press the super steam button (7) down
firmly.
- Pause for at least 5 seconds between each
jet of steam.
SELF-CLEANING
CAUTION! Do this operation over a sink. To
keep steam production constant occasional
cleaning is recommended as limescale can
build up inside the steam ducts and steam
chamber.
To do this fill the water tank (2), setting the
temperature regulator (8) to the "MAX"
position. Plug the appliance in and when the
lamp (9) goes out press the steam control
(5) down to the "Self-clean" position (Fig.
5).
Keep the button held down until water stops
coming out through the steam holes.
As soon as you release the steam control (5)
it will automatically go back to the "Max"
position (Fig.4)
CREASE REMOVAL IN VERTICAL
- Set the temperature control (8) between
the •• and Max settings and wait until the
iron reaches temperature.
- Hang the garment on a hanger and place
the iron some 10-20 cm away. Never iron a
garment if somebody is wearing it at the time
(Fig. 8).
- Press the super steam push button (7)
pausing for at least 5 seconds between each
press.
ANTI-DRIP SYSTEM
This iron is equipped with an anti-drip safety
system which automatically cuts off steam
production whenever the selected
temperature setting is too low.
PV1410/12
EMPTYING OUT THE WATER TANK
Take the plug out of the mains socket, open
the lid on the filling spout and empty out
the tank by holding the iron pointed-end
down and shaking it gently.
STORAGE
It is advisable to store the iron in the upright
position with the water tank empty and the
steam regulator set to "0".
CLEANING & MAINTENANCE
Avoid scratching the iron; do not pass it over
hard surfaces. Traces of starch or sprays can
be removed from the base by using damp
cotton wool or a non abrasive cleaning
product.
Do not put chemicals or detergents into the
water tank.
The outside surfaces can be cleaned down
with a damp cloth, without ever having to
use abrasive agents or solvents.
REPAIRS
Should the cable and/or the appliance
become defective do not hesitate in taking
it to an Authorised Technical Service Centre.
ADVICE ON DISPOSAL:
Our goods are shipped in optimised
packaging. This basically consists in using
non-contaminating materials which should
be handed over to the local waste disposal
service as secondary raw materials. Your local
town council can give you information about
how to dispose of obsolete appliances.
7 6/7/04, 09:56