STEINEL L 830 SC Bedienungsanleitung Seite 19

5. Mounting
• Check all components for damage.
• Do not use the product if it is damaged.
• When installing the sensor-switched light, make sure the installation site is
not exposed to vibration.
• Select an appropriate mounting location, taking the reach and motion
detection into consideration.
Mounting procedure (L 830, L 835, L 840 SC/C)
• Switch OFF power supply. (Fig. 4.1)
• Undo retaining screws and detach light cube from the wall mount. (Fig. 5.1)
• Mark drill holes (Fig. 5.2)
• Drill holes and fit wall plugs. (Fig. 5.3)
• Pierce sealing plug.
• Installation with concealed power supply lead (Fig. 5.4)
• Installation with surface-mounted power supply lead (Fig. 5.5)
• Connect conductors (Fig. 5.6)
• Fit light cube onto wall mount (Fig. 5.7)
• Screw in retaining screws (Fig. 5.7)
• Switch ON power supply (Fig. 5.7)
• Make settings via app (SC only)
➔ "6. Function"
Mounting procedure (GL 80 SC/C)
• Switch OFF power supply (Fig. 4.1)
• Undo retaining screw and remove light cube from the cover (Fig. 5.8)
• Pull cable through base plate and profile (Fig. 5.9)
• Screw base plate to profile (Fig. 5.10)
• Mark base plate drill holes (Fig. 5.11)
• Drill holes and insert screw anchors (Fig. 5.12)
• Screw base plate to the floor/ground (Fig. 5.13)
• Screw cover onto profile (Fig. 5.14)
• Connect conductors (Fig. 5.15)
• Fit light cube to cover (Fig. 5.16)
• Screw in retaining screw (Fig. 5.16)
• Switch ON power supply (Fig. 5.16)
• Make settings via app (SC only)
➔ "6. Function"
6. Function
The functions can be set for the SC types.
Functions are set via the Smart Remote app.
- 36 -
Smart Remote app
To configure the light via smartphone or tablet, you must download the
STEINEL Smart Remote app from your app store. You will need a Blue-
tooth-capable smartphone or tablet.
Android
Functions that can be set via Smart Remote app are:
– Time setting
– Reach adjustment
– Twilight setting
– Night-light function
– Main light / night light level can be adjusted
– Extended reach adjustment
– Group interconnection
– Twilight setting by teach-in
Time setting (stay-ON time)
The light's ON time can be set to any period from approx. 5 seconds to a
maximum of 60 minutes. Any movement detected before this time elapses will
restart the timer.
This function only ever applies to the C types in combination with a
Bluetooth sensor-switched product.
Note:
After the light switches OFF, it takes approx. 1 second before it is able to start
detecting movement again. The light will only switch ON in response to
movement once this period has elapsed.
The shortest time setting is recommended when adjusting the detection zone
and performing the functional test.
Reach setting (sensitivity)
Reach is the term used to describe the diameter of the more or less circular
detection zone produced on the ground after mounting the sensor-switched
light at a height of 2 m.
– Control dial set to maximum = max. reach (5 m)
– Control dial set to minimum = min. reach (1 m)
iOS
- 37 -