Master-Slave - Laserworld CS-1000RGB Bedienungsanleitung

Laserworld CS-1000RGB
Stand-alone, or Auto, operation allows for playback of the internal patterns without any control.
They are played back according to the internal system settings.
Select „AUto" by navigating with the „Up" / „Down" buttons and confirm with „Enter":
Standard Selection is „All", which means that all patterns saved on the main board are played
back. You can decide to use ony a certain part of the pattern set by selecting L001, L002, L003,
L004 or L005:

8.2.3. MASTER-SLAVE

The CS-1000RGB is Master-Slave capable. this means that the Master laser system can hand on a
control signal to one or more Slave lasers, so all do the same.
Master-Slave only works with lasers of the same product series of the same product generation.
A: Link lasers with DMX cable
To use Master-Slave operation, link the Master with the Slave lasers with DMX cable. Make sure to
use the „DMX out" port on the Master and the „DMX in" on the Slave lasers. If several Slave lasers
are used, link the first one to the Master laser and daisy-chain the control signal from the first Slave
laser to the second etc..
B: Activate Master Laser
The Master laser needs to be set as control source.
Select „SEt" by navigating with the „Up" / „Down" buttons and confirm with „Enter":
use the „Up" / „Down" buttons to navigate to „uASt"
Press „Enter", use the „Up" / „Down" buttons to switch the option to „on" and confirm with „Enter"
9 / 45