Ilda / Computer Control - Laserworld CS-1000RGB Bedienungsanleitung

Press „Exit" to return to the settings menu.
Microphone Sensitivity Settings
The sensitivity of the built-in microphone for the control of the sound-to-light operation can be
adjusted in the „SEnS" menu. Press „Enter" to change the settings. Use the „Up" / „Down" button to
change the selection.
The sensitivity can be adjusted between 1 and 100. Standard value is 50.

8.2.6. ILDA / COMPUTER CONTROL

The laser can be used with any laser control software that
supports the ILDA control signal via sub-d connector. Use
an ILDA cable to connect the Digital Analog Converter
(DAC / ILDA interface) of the laser software to the ILDA in
port at the laser.
The laser automatically detects if a DAC is connected and
switches to ILDA operation. For safety reasons always
make sure to first switch the laser to DMX operation
mode (See 8.2.4. DMX Operation) before you connect the
ILDA cable, to prevent unintended laser emission if the
ILDA cable is removed by accident.
Recommended computer control software for your laser:
Showeditor Set with ShowNET
Showcontroller Set with ShowNET
14 / 45
www.showeditor.com
www.showcontroller.com
Laserworld CS-1000RGB