Operation; Turn On The Laser System; Set Operation Modes; Sound-To-Light - Laserworld Club-Serie Bedienungsanleitung

8.

Operation

8.1. Turn on the Laser system

• Connect the power cable to the device and then to the mains
• Insert key and turn it to „ON"
• Press the „ON" switch to turn on the device
• An Interlock bridge adapter is included in delivery (small network plug). Attach an E-Stop to the
interlock interface or use the bridge connector to enable laser output
• Safety Presets
This device has an integrated Scan Safety. Is the Scan Safety active (on), single beams
are prevented. Only disable the Scan Safety for testing purposes. Do not switch off the
Scan Safety for productive use of the laser! Read more: 8.2.5. Settings

8.2. Set Operation Modes:

The different operation modes can be selected via the four buttons next to the „Settings" display.
„Enter" confirms a selection or navigates to the selected menu item
„Up" / „Down" allows for stepping through the current menu or to make a selection
„Exit" exits the current menu item and moves one level higher.

8.2.1. SOUND-TO-LIGHT

Sound-to-light operation allows to playback the integrated patterns to the beat of music or any
noises.
Select „SoUd" by navigating with the „Up" / „Down" buttons and confirm with „Enter":
Standard selection is „ALL", which means that all patterns saved on the main board are played
back. You can decide to use ony a certain part of the pattern set with a certain grating by selecting
L001, L002, L003, or no grating with L004:
To set the sensitivity of the internal microphone, refer to chapter „8.2.5. Settings"
8 / 46
Laserworld Club Series Laserworld Club Series

8.2.2. STAND-ALONE / AUTO

Stand-alone or Auto operation allows to random playback the internal patterns.
They are played back according to the internal system settings.
Select „AUto" by navigating with the „Up" / „Down" buttons and confirm with „Enter":
Standard selection is „All", which means that all patterns saved on the main board are played
back. You can decide to use only a certain part of the pattern set with a certain grating by selecting
L001, L002, L003, or no grating with L004:

8.2.3. MASTER-SLAVE

This laser is Master-Slave capable. This means that the Master laser system can hand on a control
signal to one or more Slave lasers, so all do the same.
Master-Slave only works with lasers of the same product series of the same product generation.
A: Link lasers with DMX cable
To use Master-Slave operation, link the Master with the Slave lasers with DMX cables. Make sure
to use the „DMX out" port on the Master and the „DMX in" on the Slave lasers. If several Slave
lasers are used, link the first one to the Master laser and daisy-chain the control signal from the first
Slave laser to the second etc..
B: Activate Master Laser
The Master laser needs to be set as control source.
Select „SEt" by navigating with the „Up" / „Down" buttons and confirm with „Enter":
Use the „Up" / „Down" buttons to navigate to „uASt"
9 / 46