Dmx 512 - Laserworld CS-1000RGB Bedienungsanleitung

Laserworld CS-1000RGB
C: Deactivate Master setting on Slave lasers
As soon as the Master option is set to „on", the laser sends out the control signal for the Slave
units. Make sure that all Slave units have the Master setting set to „off":
D: Set Sound-to-Light or Auto mode on Master laser
To use the Master-Slave operation: Set the Master to either Sound-to-Light mode (8.2.1) or Auto
mode (8.2.2.).
E: Establish link to Slave lasers
The Slave units must be set to DMX („d512") mode and must be assigned address 001 (see 8.2.4.

DMX 512)

8.2.4. DMX 512
The DMX mode requires a DMX controller or a Master laser (see 8.2.3. Master-Slave operation) to
be connected to the laser.
To switch to DMX mode, select „d512" by navigating with the „Up" / „Down" buttons and confirm
with „Enter":
The submenu for setting the DMX address loads:
Press „Enter" and the „Up" / „Down" buttons to set the desired DMX address.
10 / 45