Dmx 512; Dmx Chart - Laserworld Club-Serie Bedienungsanleitung

Press „Enter", use the „Up" / „Down" buttons to switch the option to „on" and confirm with „Enter"
C: Deactivate Master setting on Slave lasers
As soon as the Master option is set to „on", the laser sends out the control signal for the Slave
units. Make sure that all Slave units have the Master setting set to „oFF":
D: Set Sound-to-Light or Auto mode on Master laser
To use the Master-Slave operation: set the Master to either Sound-to-Light mode (8.2.1) or Auto
mode (8.2.2.).
E: Establish link to Slave lasers
The Slave units must be set to DMX („d512") mode and must be assigned address 001 (see 8.2.4.

DMX 512)

8.2.4. DMX 512
The DMX mode requires a DMX controller or a Master laser (see 8.2.3. Master-Slave operation) to
be connected to the laser.
To switch to DMX mode, select „d512" by navigating with the „Up" / „Down" buttons and confirm
with „Enter":
The submenu for setting the DMX address loads:
Press „Enter" and the „Up" / „Down" buttons to set the desired DMX address.
10 / 46
Laserworld Club Series Laserworld Club Series
Confirm with „Enter" and press „Exit" to return to the main menu.

DMX Chart

The laser uses 14 DMX channels, so make sure that the next device uses an address that doesn't overlap
with this range.
Channel
1
2
3
4
5
6
7
8
9
10
11
Value
Operation mode 0 - 49
50 - 99
100 - 149
150 - 255
Pattern select 0 - 255
Rotation (Z-axis) 0 - 127
128 - 191
192 - 255
X-axis Rotation 0 - 127
128 - 255
Y-axis Rotation 0 - 127
128 - 255
X-axis Movement 0 - 127
128 - 255
Y-axis Movement 0 - 127
128 - 255
Size X 0 - 255
Size Y
0 - 255
Pattern gradient 0 - 255
Scan speed / Points 0 - 127
128 - 255
Function
Laser off
Sound-to-Light mode
Stand-alone mode
DMX mode
Pattern selection
(refer pages 44 – 46
for full pattern overview)
Rotation angle selection
Rotation counter-clockwise speed
Rotation clockwise speed
Rotation X position steps
Rotation X speed
Rotation Y position steps
Rotation Y speed
X-axis movement position
X-axis movement speed
Y-axis movement position
Y-axis movement speed
Size X from big to small
Size Y from big to small
Gradient speed
Scan speed
Point speed
11 / 46