Operating Elements And Connections; Front Panel; Rear Panel - Omnitronic DJP-900NET Bedienungsanleitung

4 Operating Elements and Connections

4.1 Front panel

No. Element
1 POWER switch
2 AUX input
3 INPUT select switch
4 LEVEL control
5 LOW & HIGH sound controls
6 MIC LEVEL control
7 MIC IN input
8 IR sensor
9 Display
10 Navigation buttons
11 TUNE/SELECT control

4.2 Rear panel

No. Element
12 LAN jack
13 Digital outputs (optical)
14 WiFi antenna jack
15 Radio antenna jack
16 INPUTS LINE 1-4 jacks
17 OUTPUT jack
18 MODE switch
19 OUTPUTS terminals
20 Power input
21 Fan
Function
Turns the unit on and off
3.5 mm jack to connect audio devices with line level; when this jack is
connected, the radio will be muted
To select the signal source (LINE 1/2/3/4 or AUX/RADIO)
Adjusts the volume of the speaker outputs
Adjust the high and low frequencies at the speaker outputs
Adjusts the microphone volume
Connector for microphone (combination XLR/6.3 mm jack)
Sensor for remote control
2.4'' TFT display
MENU sets operation mode, BACK ◄ and FORWARD ► select menu
items and settings
Rotate to select options and to set the headphone volume
Press to confirm settings
Function
To connect a router via a network cable
Toslink and coaxial connector to connect audio devices with digital input;
these outputs carry the signal of the Internet radio
To connect the supplied rod antenna
To connect the supplied wire antenna for DAB/FM reception
Stereo RCA inputs for audio units with live level (e.g. CD player, tuner)
Stereo RCA outputs for connection to units with line level inputs (e.g. mixer
or additional amplifier); the level is independent of the position of the
controls LEVEL (4), LOW and HIGH (5).
• STR: stereo operation with two speakers
• BRGD: bridge operation with doubled output power with one speaker
• + (red) and ‒ (black): for connecting speakers in stereo mode
• R (red) and L (red): for connecting a speaker in bridge mode or 100V mode
Used to plug in the supplied power cable
To prevent overheating: do not cover!
32 • EN