Cleaning - X4-Life Smd3014 Bedienungsanleitung

RGB LED Strip
Insert a new type CR2025 battery.
Make sure the polarity is correct. This is shown on the back of
the remote control.
Slide the battery housing into the battery compartment of the
remote control until it clicks into place.
Dispose of the old battery properly to reduce the impact on
the environment -> Chapter "Disposal"
Protection class IP65 explanation
• Dusttight: No dust penetration occurs at a vacuum of 20 mbar
inside the housing.
• Protected against a water jet: Water from any direction at
approx. 12.5 liters/minute.

Cleaning

WARNING!
Electric current presents a danger of death! Dangerous
situations can arise if the RGB LED Strip and its components
are cleaned while the power is on.
• Always disconnect the plug from the mains before you clean
the product.
28