Cable And Plug - X4-Life SMD3014 Bedienungsanleitung

GB
USER MANUAL
always a risk of an electric shock. Therefore please pay special
attention to the following:
• Make sure that the plug is accessible so that it can be taken
out of the socket immediately in an emergency.
• Do not touch the RGB LED Strip or the connecting cable if
there are signs of damage. First isolate the socket (e.g. by
switching it off at the fuse box) and then carefully take the
plug out of the socket. Do not continue to use the product
once this has occurred and instead contact the manufacturer
or take it to a service centre for repair.
• The plug of the RGB LED Strip must be taken out of the socket
to ensure that it is completely disconnected from the mains
power supply. It is not enough to switch off the unit itself.
• For safety reasons always take the plug out of the socket in the
event of a thunderstorm.
• Take the plug out of the socket during installation and
cleaning, and when the product is not in use.

Cable and plug

WARNING!
There is a risk of injury if the cable and plug are damaged!
The RGB LED Strip is powered by electric current. Therefore
please pay special attention to the following when using the
cable and plug:
• Never touch the plug with wet hands.
• If you want to take the plug out of the socket, always pull it
directly at the plug. Never pull it out by the cable, as this could
break.
• Cables must never be crushed, folded over, damaged by sharp
edges or subjected to any other kind of mechanical stress.
• Avoid exposing cables to excessive heat or cold.
• If the mains cable or another cable connected to the RGB LED
Strip is damaged, it must be replaced by the manufacturer or a
similarly qualifi ed person (e.g. a qualifi ed electrician).
21