Camp Safety GOBLIN Gebrauchsanweisung Seite 38

be connected to a fall-arrest attachment point (A) of the rescuer's EN 361 full body harness. Do not connect
must be connected to the rescuer's harness so that he can control their position and movement at all times.
The connection can be made with a connector (
can also be made with two connectors and a "Webbing Lanyard 26 cm" sling (
11 mm. Use for rescue involves additional risks with respect to single use: provide additional training to rescuers.
Avoid any possibility of slack being created on the rope, avoid lateral shifts from vertical. To calculate the minimum
clearance distance, refer to
Marking
INSTRUCTIONS FOR USE – CARABINERS
Summary
suitable for use in fall arrest systems for protecting against the risk of falling from heights. Some models are even
connectors are highlighted in Tab. K, identifying the reference code(s) on the marking of the connector(s) supplied
with the product.
Classes (Tab. K)
connector. Class H: connector for connection using a sailor's knot. Class K: Connector for via ferratas. Class X:
oval connector. Class Q: quick link. The main material that the connector is made from is indicated in Tab. K in the
"Material" column: S = Steel, SS = Stainless Steel, AL = Aluminum alloy.
Use
the fall height. The connection of the connector is indicated in the tab.K
with manual locking (
and for the connection to a reliable anchor point, and a sub-system and to other fall protection systems, see
K4. Some situations can reduce the strength of the connector. Avoid positioning situations that stress the connector
lever (
greater lever resistance (
CHECKING AND MAINTENANCE – GOBLIN
After cleaning, lubricate the pins of the moving parts with silicone-based lubricant. Note: cleaning and lubrication are
recommended after each use in a marine environment.
CHECKING AND MAINTENANCE - CARABINERS
A carabiner looses half of its resistance when the gate is open (see Tab.K): check the correct operation the lever prior
to use: The lever must return against the connector body when closed, the automatic locking device must close fully
with about external help. Mud, sand, pain, ice, dirty water and other agents can compromise the operation. Do not
use connectors with defective operation. If an operational defect appears, clean and lubricate the mechanism with a
silicon based lubricant. Clean and lubricate are recommended after each use in marine environments. If, after oiling,
and chart B.
) must avoid detaching them several times in the same working day. For the proper use
).
). In this case the device must be combined
36
). In this case the device
K1 to K4. The user of connectors