Operation; The Remote Control - Husqvarna PP 492 Bedienungsanweisung

Technical data on page 17 for water
4. Refer to
pressure.
To connect power tools
1. Use the upper connector (A) for the PRIME
products.
A
Introduction
WARNING:
product, you must read and understand the
safety chapter.
Before you operate the product
1. Read the operator's manual carefully and make sure
that you understand the instructions.
2. Do daily maintenance. Refer to
on page 15 .
3. Make sure that only approved persons are in the
work area, because there is a risk of serious injury.
4. Use personal protective equipment. Refer to
Personal protective equipment on page 6 .
967 - 002 - 11.06.2021
B

Operation

Before you operate the
Daily maintenance
2. Use the lower connector (B) to connect to wall saws.
3. For more information, refer to
page 17 .

The remote control

Use the "RETURN" button (A) to go back in the menu.
Use the arrow buttons (B) to move up and down in the
menus and the "OK" button (C) to do the selection.
OK
ON/OFF
0
Technical data on
OK
ON/OFF
0
A B C
9