Herunterladen Inhalt Inhalt Diese Seite drucken

Remote Control Battery - Husqvarna PP 492 Bedienungsanweisung

Vorschau ausblenden Andere Handbücher für PP 492:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

3. Wait until the remote control starts and the main
menu is shown on the display.
4. Push the "OK" button to get access to the main
menu.
5. Find the "SETTINGS" menu with the arrow buttons
and then push the "OK" button.
>MENU
DRIVE CHOICES
CALIBRATE ARM
SET BLADE DIAM.
[800 mm]
SETTINGS
6. Find "PAIR RADIO" with the arrow buttons and then
push the "OK" button.
>>SETTINGS
TIME & DATE
[20:51 2010-01-12]
LANGUAGE
[ENGLISH]
SET UNITS
[METRIC]
PAIR RADIO
Note:
A message on the display tells if the pairing
operation was done or not. If you cannot do a pairing
operation between the remote control and the
Troubleshooting - wall saw on page
product, refer to
15 .

Remote control battery

Note:
You must charge the remote control battery
before you use the remote control for the first time.
967 - 002 - 11.06.2021
OK
ON/OFF
0
20 DEC
20:55
20 DEC
20:55
The remote control battery is a Li-ion battery. Use only
original batteries for this product. Refer to an approved
dealer for more information.
A fully charged remote control battery can operate
maximum 8-10 hours. Cold weather decreases the
capacity and the operation time of the remote control
battery. The operation time of the remote control battery
also decreases if the display is on.
Dispose a damaged remote control battery at your
nearest service center or recycle it at an applicable
location.
Remove and install the remote control battery from the
rear side of the remote control.
To charge the remote control battery
CAUTION:
remote control battery dry and in protection
against temperature variation.
1. Connect the charger to a socket outlet.
2. Attach the remote control battery to the charger.
Make sure that the lamp on the charger comes on
and is orange.
3. Charge the remote control battery for approximately
2-3 hours to make it fully charged.
4. Remove the charger when the remote control battery
is fully charged and the lamp shows green.
Other software adjustments
Do the adjustments that follow before you operate the
product:
Note:
Refer to
Menu system overview on page 10 for
more information.
Keep the charger of the
13

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis