PEAKnx Controlmicro Schnellstart Seite 14

EN Controlmicro Short Guide
Note: Detailed instructions can be found on the supplied USB flash drive.


Avoid damage to the panel due to incorrect use!
Do not use device in safety-relevant, humid, dusty or vibration-loaded environments
■
and not under direct sunlight.
Do not allow small children to operate the device!
■
Do not make any changes, attachments or conversions to the device
■
Delivery
Controlmicro panel
■
USB flash drive: YOUVI Basic software package, Controlmicro user manual
■
Brief instructions for commissioning the panel and software
■
Connectors for KNX and power supply; Circuit board for network connection
■
Screws to secure the panel against theft, including tools
■
Adapter cable from USB type C to USB type A
■
Panel mounting and installation
Important safety and handling information
The Controlmicro may only be installed and commissioned by qualified electricians!
Observe the national regulations applicable in your country regarding installation,
functional testing, repair and maintenance of electrical products!
Observe the „Five Safety Rules" (DIN VDE 0105, EN 50110) and apply them correctly:
■
− Disconnect mains
− Prevent reconnection
− Test for absence of harmful voltages
− Ground and short circuit
− Cover or close off nearby live parts
14
Caution
Warning