Using Discs - Nintendo Wii Bedienungsanleitung

Wii_HW_MAN_FHUG-C_0807 06.09.2007
■
Removing the Controller Socket Cover
If you are using the Wii console in a horizontal position, you must remove
the controller socket cover when using Nintendo GameCube Controllers
to allow the console to lay completely flat.
1. Stand the Wii console upright as
shown and squeeze gently until you
feel a slight click.
COPY
2. Remove the cover by pulling straight up out of the console.
3. The cover can be replaced by reinserting the cover straight down
into the console until it clicks into place.
NOTE: The Nintendo GameCube Memory Slot Cover can be removed with the same procedure, and should
be removed if you are using Nintendo GameCube Memory Cards (DOL-008, DOL-014) when the Wii console
is placed horizontally.
34
12:10 Uhr Seite 34
Horizontal Position
Press in
and up
9

Using Discs

Disc Usage Precautions
Please read and follow the guidelines listed below when using Wii or Nintendo GameCube Discs in the
Wii console. Failure to do so may result in damage to your Wii console or Discs.
• Do not touch the unprinted bottom surface of the Disc. Always handle the Disc by the edges.
• Do not use cracked, damaged or repaired Discs.
• Do not bend or put excessive pressure on Discs when loading into the console.
• Do not leave Discs in direct sunlight or expose them to high temperatures, high humidity or dust, dirt or
other contaminates.
• When not using Discs, store them in their cases to prevent them from getting scratched, dirty or damaged.
• Do not write on, or place stickers on any part of the Disc.
• Do not put foreign matter on the Disc.
• If a Disc becomes dirty or contaminated with fingerprints, the system may not be able to read the game
data correctly. If necessary, clean the Disc with a soft, slightly damp cotton cloth (use water only). Clean
the Disc from the centre towards the edges; do not use a circular motion.
Wii Discs (RVL-006(EUR))
Playing a Wii or Nintendo GameCube Disc
■
Before Inserting a Disc
• Turn the power of your TV on and any other audio equipment connected to your gameplay setup.
• Select the correct input setting for your TV. (See page 20, "Input Select Information".)
■
Insert a Disc
Insert your Disc into the Disc Slot on the front of the console. The Wii console will turn on automatically.
• If your console is placed vertically, the Disc label will face to the right.
• If your console is placed horizontally, the Disc label will face upwards.
■
Starting the Game
1. Using the Wii Remote, move the cursor over the Disc Channel panel on the Wii Menu Screen and
press the A Button to make a selection.
NOTE: Please read the Disc Channel section in the separate Channels & Settings Manual included
with your Wii console for complete information on using Discs in the Wii console.
2. Select START on the game's Channel Preview Screen to begin the game.
Review the instruction booklet of the game you are playing for specific game control information.
NOTE: A Nintendo GameCube Controller is required for playing Nintendo GameCube games
and a Nintendo GameCube Memory Card is required for saving Nintendo GameCube game data.
Nintendo GameCube Discs (DOL-006(EUR))
35