Controlling Blinds And Dimmers In Jog Mode; Switching Jog Mode On And Off - RADEMACHER DuoFern Gebrauchsanleitung

Controlling blinds and dimmers in jog mode

Function: ◆ If the UP or DOWN button is pressed briefly in jog mode, a jog command is sent. This enables the easy adjustment of Venetian
blind slats as the motor only runs briefly.
◆ When used in combination with dimmers, jog mode increases or decreases the brightness by 10%.
◆ If you press and hold the UP or DOWN button (>1/2 second), the normal UP and DOWN signals are sent. Jog mode can be
switched on and off separately for each group, where applicable.

Switching jog mode on and off

1.
. . .
or
. . .
2.
approx.
10 s
. . .
or
. . .
+
3 x
i
Select the desired group with the corresponding
group button.
Press and hold the STOP button for approx. 10
seconds.
Observe the button LED and status LED:
The LED for the selected group button flashes three times
and the status LED lights up:
Green (Jog mode has been switched on).
Red (Jog mode has been switched off).
Actuators that do not support jog mode ignore jog com-
mands.
EN
55 55