Herunterladen Inhalt Inhalt Diese Seite drucken

Main Features; Hauptmerkmale; Weitere Merkmale; Montage & Kühlung - RCS AUDIO-SYSTEMS DBA-2500A Bedienungsanleitung

Inhaltsverzeichnis

Werbung

MAIN FEATURES

+ Degree of efficiency of over 90%
+ Energy saving
A+ Low heat waste
+ Low battery capacity necessary
FURTHER FEATURES
• Fully digital power amplifiers with 2 or 4 outputs each
with 500 W RMS power at 100V.
• The size of the housing enables high efficiency, minimal
heat generation and additionally a reduction in the
required installation space.
• Several LEDs are available for visual control. These
provide information about the pending signal, clip, the
protect circuit or the supply of voltage.
• Pilot tone inputs and malfunction message contacts for
emergency power and the power amplifier predestine
this amplifier for 100 V technology according to DIN VDE
0828 / DIN EN 50849.
• Two or four emergency power inputs (24V DC)
• The devices have separate speaker outputs (100 V) on
screw-type connectors, which significantly reduces the
wiring effort.
• Symmetrical, controlled LF inputs on screw-type
connectors, whereby the wiring complexity is reduced
significantly.
• Special protective circuits against short circuits,
overheating and overloading are among the features of
this amplifier series.
• Active and remote-controlled standby switch for low
power consumption.
• The thermally controlled fans (only switch on briefly
during sine full load operation) ensure effective cooling
of the amplifier so that overheating is avoided.
• Compliant with the EN 54-4 and EN 54-16, as well as
part of the certification of the VARES-3000 system.
• Suitable for A/B operation thanks to the integrated,
redundant power supplies.
MOUNTING & COOLING
Amplifier racking size for DBA-Series are designed for stan-
dard 19˝ rack mounting with additional left, right bracket.
Never block the air vents in the sides makes enough space
line 44 mm of the amplifier the following is figure of air-flow.
Check inside temperature of rack system so as not to be
more than 40°C for the stable operating in any case, we re-
commend you to install cooling fan additionally on the rear
panel of rack cabinet.
4
FEATURES

HAUPTMERKMALE

+ Wirkungsgrad von über 90%
+ Energiesparend
+ Geringe Abwärme
+ Geringe Akkukapazität notwendig

WEITERE MERKMALE

• Volldigitale Leistungsendstufen mit 2 oder 4 Ausgängen
von jeweils 500 W RMS-Leistung bei 100V.
• Die Größe des Gehäuses ermöglicht eine hohe Effizienz,
minimale Wärmeerzeugung und zusätzlich eine Reduzie-
rung des notwendigen Einbauplatzes.
• Zur optischen Kontrolle stehen mehrere LEDs zur Ver-
fügung, die über das anstehende Signal, Clip, die
Protect-Schaltung oder der Versorgung mit Spannung
informieren.
• Pilottoneingang und Störmeldekontakte für Notstrom
und Endstufe prädestinieren diese Verstärker für ELA
Anlagen gemäß DIN VDE 0828 / DIN EN 50849.
• Zwei bzw. vier Notstromeingänge (24V DC)
• Die Geräte verfügen über getrennte Lautsprecheraus-
gänge (100 V) auf Schraubsteckverbinder, wodurch sich
der Verdrahtungsaufwand wesentlich verringert.
• Symmetrisch, geregelte NF-Eingänge auf Schraubsteck-
verbinder, wodurch sich der Verdrahtungsaufwand we-
sentlich verringert.
• Spezielle Schutzschaltungen gegen Kurzschlüsse, Über-
hitzung und Überlastung gehören zu den Leistungsmerk-
malen dieser Verstärkerserie.
• Aktive und fernsteuerbare Standby-Schaltung für gerin-
gen Stromverbrauch.
• Die thermogesteuerten Lüfter (schalten sich nur bei
Sinus-Volllast Betrieb kurzzeitig an) sorgen für effektive
Kühlung des Verstärkers, so dass eine Überhitzung ver-
mieden wird.
• Konform zu den Normen EN 54-4 und EN 54-16, sowie
Teil der Zertifizierung des VARES-3000 Systems.
• Durch die integrierten, redundanten Netzteile für den
A/B-Betrieb geeignet.
MONTAGE & KÜHLUNG
Die Verstärker der DBA-Serie sind mit seitlichen Befesti-
gungwinkeln für den Einbau in 19˝ Gestelle geeignet.
Blockieren sie nie die Luftöffnungen an den Seiten (min. 44
mm Raum), um einen optimalen Kühlluftfluß zu gewährlei-
sten. Falls sie die Verstärker in ein 19"-Rack einbauen und
immer mit höchster Leistung arbeiten, sollte gegebenenfalls
in das Rack ebenfalls ein entsprechender Lüfter eingebaut
werden.
DBA-SERIES

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

Dba-4500a

Inhaltsverzeichnis