Automatic Defrost; Overload Protection - VGO OL-BKYR20-A010D Bedienungsanleitung

Cancel timer

5.4.4 Automatic Defrost

At low room temperatures, frost may buildup at the evaporator during operation.
The unit will automatically start defrosting and the POWER LED blinking. The
defrost control sequence is as follows:
A. When the unit operates in the cooling operation, drying operation, the
ambient temperature sensor senses the evaporator coil temperature is below
-1°C, after the compressor will stop operating for 10 minutes or the coil
temperature up to 7℃, the unit restart to cool operating mode.

5.4.5 Overload Protection

In the event of a power loss, to protect the compressor there is a 3-minute delay
until the compressor restarting.
Press timer key then press ADD/MINUES repeatedly
until the LED shows '00'.
Note: when press POWER will also exit the timer setting.
23