Heating Your Room; Timer Setting - VGO OL-BKYR20-A010D Bedienungsanleitung

C. Drying your room
Press MODE button on the control panel or remote control, the LED of
operation lights up. The fan speed is unable to select. User should
connect the hose to the drain outlet at the bottom of the unit.
Note: In this mode, the fan speed switches over to low speed and cannot
be selected.
D. Heating your room
Select the Heat mode to Higher the temperature in your room.
Press MODE button repeatedly until the LED of
Press ADD/MINUS button to adjust the temperature which is displayed
on the screen. The temperature can be set between 16℃ and 32℃.
Press SPEED button repeatedly until the desired fan speed indicator lights
up.
To control the direction of the air flow horizontally, please adjust the
inner louver by hand.
Note： The air conditioner stops if the room temperature is higher than
selected temperature.
E. Sleep mode （ this function can only be used with a
remote control）
The sleep mode can be activated when in cool mode
In cool mode :

After 1 hour the preset temperature is increased by 1 ℃, after another
hour the preset temperature will again be increased by 1 ℃.

5.4.3. TIMER SETTING

The timer has two ways of operation:
To turn off
(When power on)
To turn on
(When power off)
（1hour-24hours）:
Press Timer key to
turn on the timer
function.
Press Timer key to
turn on the timer
function.
22
operation lights up.
Press ADD/MINUS
repeatedly to set the
delay OFF time.
Press ADD/MINUS
repeatedly to set the
delay ON time.