Shutting Off The Engine; Operating The Traction Drive; Operating The Speed Selector; Operating The Auger/Impeller Drive - Toro Power Max Heavy Duty 928 OAE Bedienungsanleitung

Shutting Off the Engine

Important:
Wait for all moving parts to stop before leaving the operating position.
Operating the Traction
Drive
CAUTION
If the traction drive is not properly adjusted,
the machine may move in the direction
opposite of what you intended, causing injury
and/or property damage.
Carefully check the traction drive and adjust it
properly, if necessary.
Important:
If the machine moves when the
traction lever is in the released position, check the
traction cable; refer to
the Traction Cable (page 19)
to an Authorized Service Dealer for service.
Important:
To operate the traction drive, you
must operate the machine with the self-propel
feature engaged.
1. To engage the traction drive, squeeze the left
(traction) lever to the handgrip
Figure 17
2. To stop the traction drive, release the traction
lever.
Checking and Adjusting
or take the machine
(Figure 17).
Figure 16
Operating the Speed
Selector
The speed selector has 6 forward and 2 reverse
gears. To change speeds, release the traction lever
and shift the speed-selector lever to the desired
position (Figure
each speed selection.
Operating the
Auger/Impeller Drive
1. To engage the auger/impeller drive, squeeze
the right (auger/impeller) lever to the handgrip
(Figure 19).
g001011
13
18). The lever locks in a notch at
Figure 18
Figure 19
g252411
g001012
g001013