Trouble Shooting - Signode Josef Kihlberg 561-15PN Betriebsanleitung

8 8
Before all trouble shooting tasks on
the stapler it must first be
disconnected from the air supply.
No staples when firing the tool.
Bad clinch
Jammed staple in the nozzle.
04.20

TROUBLE SHOOTING

TROUBLE SHOOTING
FAULT
ELIMINATION
– Check that the right type of staples is being used
and moves easily.
– Always use Josef Kihlberg original staples.
– Check if the feeder spring is not defective. If
necessary replace.
– Check if the staple pusher is not defective. If
necessary replace.
– Clean the staple track.
– Air pressure too low. Secure that working pressure
is as recommended, see chapter 6.6.
– Check if the right leg length is used and the sta-
pler is right adjusted, see chapter 6.1.
– Has the tool been used without oil? Provide lubri-
cation, see chapter 5.2.
– Remove the defective staple, see chapter 7.2.
Josef Kihlberg 561-15PN
11