Installation Instructions - Concept CA2000 Bedienungsanleitung

EN
Press the "Timer" button to set the shut-down timer. Each press changes the time by 30 minutes. The
maximum time of the timer setting is 12 hours. Press and hold the "Timer" button for 3 seconds to
cancel the timer.
Press the "UV" button to activate the UV lamp function, the button lights up. Press it again to turn the
UV lamp off.
If you press the "Auto" button again, the device will enter the automatic mode and the button will light
up. In this mode the device operates according to the degree of air pollution. PM2.5<60 (low power
of the motor), 60≤PM2.5<150 (medium power of the motor), PM2.5≥150 (high power of the motor)
If you press the "Sleep" button, the device will enter the automatic mode and all the lightning will turn
off. The motor runs at low power. A timer is available in this mode. Press any button to exit the sleep
mode.
Press the "Speed" button to change the motor speed to low (500 rpm¨, medium (700 rpm) and high
(900 rpm). The device exits the automatic mode. After pressing this button, the motor speed will not
automatically change according to the air pollution, but remain in the mode you selected.
When operating in automatic mode, the device enters sleep mode in low light. If the lighting increases
again, the device returns to its original function.
68

INSTALLATION INSTRUCTIONS

• In case of internal dust, such as pollen, the appliance should be placed on the ground. Since pollen, dust, etc. are
usually held close to the floor, it is recommended to place the purifier on a flat floor in the room.
• In order not to block the air inlet and outlet, place the appliance about 30 cm or more away from the left and right
sides of the wall, furniture, curtains, etc. For effective use of the appliance, please keep it at least 30 cm away from
the wall behind it.
• Do not cover the top of the appliance nor place any objects on it. (It could cause the appliance to malfunction.)
• Note: Do not place magnets or metal objects on the appliance.
• Do not block the air inlet and outlet, for example, do not place any objects on the air outlet. Or on the front side,
on the air inlet.
• Place the appliance at least 1 m away from TV and radio receivers. Placing it near them may cause signal
interference.
MANDATORY MAINTENANCE
• Switch off the appliance immediately if any of the following situations occur (could cause electric shock, spark or
smoke)
- Unusual sound or vibration occurs during operation.
- The appliance is unusually hot and there is a smell of burning.
• Clean the plug regularly.
- If the plug is dusty, moisture may damage the insulated part of the plug and cause a fire.
- If the appliance is not used for a long time, unplug the power cord.
- Never clean the plug or the appliance with water.
• Be sure to disconnect the power supply before performing any maintenance on the appliance. The appliance may
suddenly start and cause electric shock and injury.
• Connect the plug to the wall socket correctly (if the plug is not inserted correctly, it may result in electric shock due
to overheating or even a fire). Do not use a damaged plug or loose socket.
• Always pull the power cord by the plug. Pulling on the cord may cause damage to the power cord, electric shock,
short circuit, or fire.
• If any of the following occurs and the remedy found in the "Troubleshooting" table does not help, contact an
authorized service centre.
- The power button does not work.
- The power cord or plug is unusually hot.
- You noticed unusual sound or vibration.
- There are any other abnormalities or faults.
• To prevent electric shock, unqualified persons should not disassemble the appliance.
CA2000 CA2000
EN
69