Replacing Blades - Pregis AirSpeed MINI PAK'R Bedienungsanleitung

Replacing Blades

Maintaining
the MINI-PAK'R
Machine
!
2
Remove Slitting Blade
Cartridge and dispose of
properly.
Risk of Burn!
Before opening
Covers, turn Power
OFF, unplug the
Power Cord, and
wait 10 minutes for
Seal Bar to cool.
Replace the Slitting Blade Cartridge: Table of Table of
• If the film jams frequently.
Contents Contents
• After 50 Film Rolls have been processed.
• If the Blade is not cutting the film properly or is
making a very rough cut.
1
Turn Power OFF, unplug Power Cord, then wait
10 minutes for Seal Bar to cool. Open Belt Cover
with Slotted or Phillips Screwdriver.
To reinstall newly ordered, red cartridge, slide
3
front end of cartridge into the Fill Tube. Push the
cartridge toward the tube until you feel the back
snap into place.
3
MINI PAK'R 제조기 사용자 설명서 -14- 페이지
MINI PAK'R Machine User Manual Page -14-
Replacing Blades
!
2
Remove Thumbscrew
Risk of Burn!
then Blade Assembly.
Before opening
Covers, turn Power
OFF, unplug the
Power Cord, and wait
10 minutes for Seal
Bar to cool.
MINI PAK'R Machine User Manual Page -15-
Replace the Slitting Blade:
• If the film jams frequently.
• After 50 Film Rolls have been processed.
• If the Blade is not cutting the film properly or is
making a very rough cut.
1
Turn Power OFF, unplug Power Cord, then wait
10 minutes for Seal Bar to cool. Open Belt Cover
with Slotted or Phillips Screwdriver.
3 Remove Blade with 1.5mm Hex
Wrench. Flip Blade over or Replace
Blade if both sides of Blade have
been used. Reinstall Blade
Assembly.
1.5
mm
hex