Basic
Set Length Control per use
(measured in feet or
Operation
meters, depending on
country of purchase)
Green LED
Blinks while warming up
Solid when ready.
Start Button
•
Warm up MINI PAK'R
Machine
•
Start production of Air
Cushions
When the correct temperature is reached, the green
LED will remain solid green. The display will show "rdy"
(Ready). The MINI PAK'R Machine is ready for production.
Press the Start Button to begin making Air Cushions.
Display
Set Air Fill Level
Set Seal Temperature
Red LED
Stop Button
•
Stop Production
•
Reset MINI PAK'R
machine after error
is corrected
Initially, the display will show "sty" (Standby). Once the film
is loaded, the MINI PAK'R Machine will detect the roll. The
green LED on the Start Button will begin flashing. A flashing
green LED indicates that the Machine is warming to the
correct seal temperature. The Control Panel will display seal
temperature while adjusting.
MINI PAK'R 제조기 사용자 설명서
-10- 페이지
MINI PAK'R Machine User Manual
Page -10-
Start Production
When the green LED remains steady green,
and the Display reads "rdy" (Ready), press
and release the Start Button again to begin
production. The Air Pump will force air into
the film, and after a few seconds the Drive
Motor will advance the inflated Air Cushions
through the Seal Bar and past the Slitting
Blade. Air Cushions will emerge at the front
of the MINI PAK'R Machine.
Press the Stop Button to stop production.
The MINI PAK'R Machine is factory set
in continuous mode, and will create Air
Cushions until the Film Roll is empty. To
create a fixed length of Air Cushions, use
the Length Control buttons (next page).
If the MINI PAK'R Machine is not used for
Standby mode
90 minutes, it will enter "Standby" mode.
The Display will read "Sty". To resume Air
Cushion production, press the Reset Button.
The Seal Bar will begin heating. Press the
Start Button again when the green LED
remains steady green and the Display reads
"rdy" to resume Air Cushion production.
MINI PAK'R Machine User Manual
Page -11-