Inhaltsverzeichnis
Werbung
Changing MINI PAK'R Machine Settings
Machine
The MINI PAK'R Machine automatically chooses the correct air and temperature settings
Settings
for the Film Roll you have loaded. You do not need to adjust Machine settings manually.
However, if the automatic settings are not optimal, the Control Panel allows you to change
the following settings.
Length Control
Length Control sets the length of Air Cushions to be produced each time you press the
Start Button. You have 2 options:
NOTE on Length Control Display
Model # MMP01MNPKR ( Item # 4075536 ) – 120V 3.15A – will display length units in FEET.
Model # MMP02MNPKR ( Item # 4075540 ) – 230V 1.6A – will display length units in METERS.
Table of
Table of
Contents
Contents
Continuous Mode
Length Control at the factory is preset at continuous production.
Press the Start Button and the machine will run the film until the
Film Roll is empty or the Stop Button is pressed. The Machine will
display the length of Air Cushions produced.
Fixed Length
If you want to produce a fixed length of Air Cushions, press the
+ Button until the desired length is displayed. The Machine will
count down the length of Air Cushions yet to produce.
To change from Fixed to Continuous mode, press the - Button
until the Display shows "- - -"
MINI PAK'R 제조기 사용자 설명서
MINI PAK'R Machine User Manual
Air Control
Air Control regulates the amount of air
in the Air Cushions.
If you want fuller Air Cushions, press
the + Button.
If you want less full Air Cushions, press
the - Button.
-12- 페이지
Page -12-
MINI PAK'R Machine User Manual
Temperature Control
The Temperature Control regulates the temperature of the Seal Bar that
fuses the front and back film sheets together.
If the Air Cushions become flat, and upon inspection the Heat Seals are
leaking air, increase the Temperature Control by pressing the + Button.
If the Air Cushions become flat because the seals are burned through
at the seal line as evidenced by holes in the Air Cushions, decrease the
Temperature Control by pressing the - Button.
NOTE: After changing the Temperature Control
setting, the MINI PAK'R Machine may take a few
moments to establish the new seal temperature.
During heat-up or cool down, green LED will
flash until the correct temperature has been
achieved.
If Air Cushions continue to show poor seals and
produce flat cushions, contact us for assistance.
Page -13-
Werbung
Kapitel
Inhaltsverzeichnis
