Adjusting The Fan Speed; Turbo Mode; Drying Function; Energy Saving Function - Airwell XDA Bedienungsanleitung

ADJUSTING THE FAN SPEED

AUTOMATIC
Simply set the FAN selector to the
microcomputer automatically controls the fan speed when
the AUTO mode is selected. When the air conditioner
starts operating, in heating or cooling, the fan speed varies
according to the thermal load of the room.
NOTE
The automatic speed is not available in FAN ONLY mode.
MANUAL
If you want to manually adjust speed just set the FAN
selector as desired.
Low speed Med. speed
SLEEP MODE
1. Set the MODE selector to COOLING or HEATING
mode.
2. Press the SLEEP button.
3. The mark appears on the display. Press the
button again to release the function.
What does the SLEEP mode mean?
When you select the SLEEP mode, the air conditioner
automatically limits the power supplied to increase comfort
during the night.
How does the SLEEP program work?
Cooling + sleep mode:
The fan speed is reduced by 1 step on the basis of the
set fan speed.
After 1 hour of operation, the set temperature is increased
by 1 degree.
After 3 hours of operation, the set temperature is increased
by 1 degree.
After 8 hours of operation, the program will be automatically
canceled, the set temperature will return to the original set
temperature and the air conditioner continue to run.
Heating + sleep mode:
The fan speed is reduced by 1 step on the basis of the
set fan speed.
After 1 hour of operation, the set temperature is reduced
by 1 degree.
After 3 hours of operation, the set temperature is reduced
by 2 degrees.
After 8 hours of operation, the program will be automatically
canceled, the set temperature will return to the original set
temperature and the air conditioner continue to run.

TURBO MODE

You can select TURBO only during cooling or heating
position. A
mode and not during automatic, dehumidifying (dry) and
fan mode. TURBO mode allows to obtain the maximum
air conditioner's efficiency, either in cooling or heating
mode (heat pump). The user can choose to activate the
TURBO mode, using the remote control unit, after having
selected cooling or heating mode. Under these conditions
the air conditioner will reach its maximum thermal power;
it is recommended to use the TURBO mode only if the
outdoor temperature is extreme and the selected room
temperature is difficult to be reached. On the contrary,
if you want to obtain the best performance in efficiency
and silentness, TURBO mode is not recommended: let
the air conditioner run in normal condition (factory default
program).
To activate TURBO mode it is necessary (after having
selected the cooling or heating mode) to press the TURBO
High speed
button, so that the word TURBO appears on the remote
control's display.
Press the button TURBO again to deactivate this function.

DRYING FUNCTION

You can select DRYING function only during cooling or
dehumidifying mode.
Press the DRYING FUNCTION button (BLOW) to activate
this function and the word DRYNESS appears on the
remote control's display.
When this function is activated, after pressing the on/off
button to turn off the air conditioner, it will continue to run
for a few minutes in the breeze to remove the residual
water on the evaporator surface.
Press the DRYING FUNCTION button again to deactivate
this function.

ENERGY SAVING FUNCTION

You can select ENERGY SAVING function only during
cooling mode.
Press the ENERGY SAVING button (HEALTH SAVE) to
activate this function: the word HEALTH appears on the
remote control's display and the word SE appears instead
of the temperature value.
When this function is activated, the temperature is
automatically set to 25°C and the fan speed is changed
to automatic speed. The temperature setting and the fan
speed setting are no more valid.
Press the ENERGY SAVING button again to deactivate
this function.
7
EN