Safety Instructions - Graf EcoBloc Inspect Smart Anleitung Für Den Betrieb Und Die Wartung

1.

Safety Instructions

This documentation only relates to use of the GRAF EcoBloc infiltration/attenuation systems for retaining,
storing or infiltrating surface & rainwater. Any other use of the infiltration/attenuation system must be
agreed with Otto GRAF GmbH from a technical, material and/or structural viewpoint.
Should special requirements apply, we would also recommend contacting architects or planners with
knowledge of hydrology and geology.
The maintenance instructions of all other parts of the stormwater management system must be noticed
and followed in any case. Accessories from other manufacturer's must be maintained in accordance of
the manufacturer's maintenance instructions.
1. Safety Instructions
All work should be undertaken in compliance with the relevant accident
prevention regulations according to national standards.
Only authorized and qualified personnel should install, inspect and clean the
system. The following safety and installation instructions should also be
noted.
Please ensure a correct storage. This means away from negative influences
such as fuel, lubricants, chemicals and acids.
Before entering or inspecting any part of the system, make sure the
complete system is out of order. Otherwise there is a danger to life!
The shaft cover needs to be closed at any time, except during operations at
or inside the system. There is a high risk of accidents, if the shaft cover is
not in position! The correct position of all covers needs to be checked
regularly.
There is an increased risk of slipping on Graf EcoBloc in frosty and wet
conditions.
GRAF provides an extensive range of accessories, which are all coordinated
and can be combined to form complete systems. Using other manufacturer's
accessories or components may result in the system's reduced performance
or failure and liability for damage or costs will not be accepted.
11 / 18